When the fire pump water leakage problem, we should first find out the location and cause of water leakage, and then timely repair. If the device is not processed for a long time, the device usage will be greatly affected. So, we first briefly understand how to solve the fire pump leakage problem.
1. The sealing ring of the Fire Pump Equipment loses elasticity due to long-term use. At this time you can take out the sealing ring, and then find a piece of 0.3 to 0.5 mm thick paper or cloth, cut into a slightly larger pad than the original sealing ring installed in the groove, the original sealing ring mounted.
2, the rubber sealing ring inside the nylon seal seat wear, can take out the sealing ring, and then exchange azimuth equipment, such as the fastening spring on the sealing ring lose elasticity or cracking, can remove the spring, with a proper diameter of steel wire or wire tight.
3, a serious wear of the sealing ring out of the nylon sealing ring, and then coated with butter asbestos rope, wound in the stainless steel sleeve filling to slightly higher than the original nylon seat, and then filled with butter, and then the nylon seat with bolts compaction.
4. The sealing ring between the fire pump sealing box and the cast iron loses elasticity. Take the sealing ring out of the cast iron groove, find a 0.6-1mm thick cardboard shell, cut it into the same standard, put it into the groove, and then put the sealing ring in the fire pump.
5, oil hole rubber sealing ring damage, can find a piece of tape, cut into a hole slightly larger than the bolt, add flat pad above, set together in the bolt into the oil hole.
When dealing with the leakage fault, we should follow the above processing steps, and then according to the corresponding conditions and requirements of the Portable Fire Fighting Water Pump timely maintenance, as far as possible to avoid the occurrence of similar problems, so timely maintenance is good.
Post time: May-14-2022